USER MANUAL APS 6.0

Configuring Y our Programming Device for Online Communication
11–7
Note When using the serial port with APS, COM1 must use IRQ 4 and COM2 must use
IRQ 3.
Once you select the 1747-PIC Interface Converter the following addresses must be
set:
Terminal Node Addresses
The DH-485 network requires you to set unique node addresses for the terminal and
each processor or other devices on the network. This section describes how to set
the node address for the APS terminal and the default APS processor. The default
APS processor address is the node the APS terminal attempts to establish
communication with when you go online.
Setting
APS T erminal Node Address: The default node address for an APS terminal
is 0. To change the terminal address, do the following:
1.
Press
CONFIG
OFFLINE
CONFIG
TERM
ADDRESS
F4
.
2. Type any number between 0 and 31.
3.
Press [ENTER].
Note The
terminal addr ess cannot equal the pr ocessor addr ess.
Setting
Default APS Processor Addresses: The address of the processor APS will try
to communicate with when you attempt to go online from the main menu. To
change the processor address, do the following:
1. Press
CONFIG
OFFLINE
CONFIG
PROC
ADDRESS
F5
.
2. Type any number between 1 and 31.
3.
Press [ENTER].