USER MANUAL APS 6.0

Protection
8–11
Fixed and SLC 5/01 Processor
The
output file is always statically protected. Y ou cannot alter the output data file
while in the REM Run mode using the communication channels. However , all other
data table files are unprotected.
SLC 5/02 Processor
You can choose to statically protect your data table files at the time you save your
program. When you press [F2], Save from the Program Directory display, the
following screen appears:
File Name: EXAMPLE
F1 Single Step Test DISABLE
F3 Index Across Files: DISALLOW
F4 File Protection OUTPUTS
F6 Future Access: ALLOW
ESC exits
F1 F6F3 F4
F8
SINGLE
STEP
FUTURE
ACCESS
INDEX
CHECKS
FILE
PROTECT
YES
FILE ALREADY EXISTS
Overwrite File?
offline SLC 5/02 File EXAMPLE
F10
NO
Apply protection to your data table file by pressing
CONFIG
OFFLINE
CONFIG
FILE
PROTECT
F4
.
This key [F4], toggles between:
• Output - only the output file is statically protected (default).
• All - all files are statically protected.
• None - no files are protected.
For more information on saving your file(s), see chapter 9.