QUICK START GUIDE APS 6.0 User Manual
Preface
APS Quick Start for New Users
A–10
3. Return to the APS menu.
Press
CONFIG
OFFLINE
CONFIG
RETURN
TO MENU
F3
.
Test Your Ladder Program
Complete the following steps to test the timer instruction file:
1. Go online with your processor and restore the new file. Refer to chapter 4 for
help.
2. Monitor the file. Refer to chapter 4 for help.
3. Place the processor in the RUN mode. See chapter 4 for help.
4.
Press pushbutton #0 for at least 10 seconds. During the first 10 seconds, output
#3 turns ON and #4 stays OFF
.
5. After 10 seconds, output #3 turns OFF and output #4 turns ON.
6. Release pushbutton #0; the timer resets and both outputs #3 and #4 turn OFF.