QUICK START GUIDE APS 6.0 User Manual

Preface
APS Quick Start for New Users
A–6
Entering
a T
imer Instruction
In exercise 2, you enter a timer instruction with a time delay of 10 seconds. Two
different types of timer status bits activate output pilot lights #0 and #1. The first
type, called a “timer timing” status bit turns on output #0 for 10 seconds. The
second type, called a “done” status bit, turns on output #1
after
10 seconds.
Exercise 2: Entering a Timer Instruction
We are assuming you have created a new file, configured it and you are now ready
to begin entering an instruction. See chapter 3 for help with the above. Begin
offline at the edit screen.
1. Enter a rung and an XIC instruction.
Press
CONFIG
OFFLINE
CONFIG
APPEND
RUNG
F3
, then
CONFIG
OFFLINE
CONFIG
INSERT
INSTR
F4
, then
CONFIG
OFFLINE
CONFIG
BIT
F1
, then
CONFIG
OFFLINE
CONFIG
XIC
-] [-
F1
. T
ype the
address
I:1/0
then press
[ENTER].
] [
I:1
0
END
2. Enter the timer instruction.
Press
CONFIG
OFFLINE
CONFIG
TIMER
COUNTER
F2
, then
CONFIG
OFFLINE
CONFIG
TON
F1
.
T
ype the address
T4:0
then press
[ENTER]. This is the T
imer Address.
T
ype the timebase
.01
then press
[ENTER]
. This is the timebase in seconds.
T
ype
1000
then press
[ENTER]. This is the Timer Preset Value in hundredths
of a second.