QUICK START GUIDE APS 6.0 User Manual

Creating a Processor File
3–11
5. Enter the Output instruction on the rung.
Press
CONFIG
OFFLINE
CONFIG
BIT
F1
, then
CONFIG
OFFLINE
CONFIG
OTE
-( )-
F3
. T ype the address O:3/0 , then press
[ENTER].
6. Accept the rung.
Press [ESC], then
CONFIG
OFFLINE
CONFIG
ACCEPT
RUNG
F10
, then [ESC].
Add a Rung Comment
Complete the following steps to add a rung comment:
1. Configure the display so that rung comments will be visible.
Press
CONFIG
OFFLINE
CONFIG
CONFIG
F2
DISPLAY . Make sure [F7] reads
CONFIG
OFFLINE
CONFIG
SUPPRSS
F7
RNG COM
. If it does not, press
CONFIG
OFFLINE
CONFIG
DISPLAY
F7
RNG COM
to toggle [F7], before moving to the next step.
Press
CONFIG
OFFLINE
CONFIG
SAVE
F10
CONFIG
, then [ESC]. The display is now configured so that rung
comments are visible.
2. Add the rung comment.
Press
CONFIG
OFFLINE
CONFIG
DOCUMNT
F5
, then
CONFIG
OFFLINE
CONFIG
RUNG
COMMENT
F1
. Type the comment Input pushbutton
turns on output pilot light.
3. Accept
and save the comment.
Press
CONFIG
OFFLINE
CONFIG
ACCEPT
/EXIT
F8
, then
CONFIG
OFFLINE
CONFIG
SAVE
DOCUMNT
F10
, then [ESC].