QUICK START GUIDE APS 6.0 User Manual

Setting Up Y our Equipment
1–7
Connecting the Controller to a Personal Computer
To connect the controller to a personal computer , you need a communications cable,
catalog number 1747-C10, and an RS-232/DH-485 interface converter , catalog
number 1747-PIC.
Note This
pr ocedur e does not apply to SLC 5/04 pr ocessors. For these pr ocessors, you
need to connect a 1747-CP3 cable fr om channel 0 of the pr ocessor to the personal
computer serial port, or you need to use a KT , KTX, KT2, or PCMK car d.
1. Locate the communications channel of the controller. The figure below shows
where it is located on modular and fixed controllers.
Processor Module (Modular Controller)
SLC 500 Fixed Controller
Communications Channel
Communications Channel

2. Insert one end of the 1747-C10 cable into the communications port of your
controller.
3. Insert the other end of the 1747-C10 cable into the DH-485 connector of the
1747-PIC interface converter. The DH-485 connector is shown in the following
illustration.