User Manual

11
Main screen
Fields Description
ID Tag User defined field (e.g., PT1015-2)
User reference User defined field (e.g., Pump 1015 bearing)
Input screen
Set the input type by pressing the appropriate button - relevant
fields (as shown below) will appear.
Fields Description
Engineering unit Sets the units used for the input low and high settings.
Input Low The input value corresponding to ‘zero’ (4 mA) output.
Input High The input value corresponding to ‘full scale’ (20 mA) output.
Damping factor Sets the damping factor for the inbuilt digital filter. Accepts values from
1-99.
# of samples The number of samples averaged for each measurement. The effect of this
setting depends on the input type. Normally set around 50.