Owner's manual

Connections
For effective protection from electromagnetic noise, all signal
cables must be shielded, or located on conductive trays or in
conduits.
Strip wires to 7 mm from the ends. Use a suitable ferrule for multi-
stranded wires (do not solder).
Terminal Signal
1 Supply +
Power Supply
7 Supply −
4 Voltage Input +
Voltage Input
Input Type Jumper to ‘Volts’
Field Supply Jumper to ‘Off’
3 Voltage Input −
2 Current Input +
Current Input
Input Type Jumper to ‘Current’
Field Supply Jumper to ‘Off’
3 Current Input −
3 Device +
Loop Powered Trans-
mitter Input
Input Type Jumper to ‘Current’
Field Supply Jumper to ‘On’
2 Device −
6 Voltage Output +
Voltage Outputs Output Type jumper to ‘Volts’
5 Voltage Output −
8 Current Output +
Current Outputs Output Type jumper to ‘Current’
5 Current Output −