GETTING STARTED Owner manual

Setting Up ControlNet to RIO Block Transfer Pass Thru Communications 8-11
5.
In the
Enter Starting Group #
field, type the RIO starting group number of
the drive. The RIO starting group number is set in the communications
module. Valid numbers are 0, 2, 4, and 6.
6.
Select
PLC Type
.
7.
If you are using a 1395 drive, select
Use 1395 Protocol
.
8.
Click
OK
.
The DriveTools32 application is now communicating with the drive. If you are
prompted to create a new database, click
Ye s
.
Important:
If a prompt appears to alert you that the application failed to
communicate with the drive, refer to Chapter 16,
Troubleshooting
.