GETTING STARTED Owner manual

Setting Up ControlNet to RIO Block Transfer Pass Thru Communications 8-5
5.
In the
Enter INTERCHANGE Port Mapping #
field, type the number of
the KT:0 port used by the ControlNet driver in the RSLinx
Configure
Client Applications
dialog box.
Important:
To view the KT Port number used by the ControlNet driver, select
Configure Client Applications
in the RSLinx
Communications
menu.
6.
If you are using a 1336 FORCE and its drive firmware version is 0.10,
select
1336T Two Word Header (used ONLY for 1336T version 0.10)
.
7.
Click
OK
. The following prompt appears.
8.
Read the information, and then click
OK
to save the configuration.
Connecting to the Drive
After configuring RSLinx and the DriveTools32 application, you are ready to
connect to a drive.
1.
In the
Drive
menu, select
Connect to Drive
. The
RIO Pass Through
Network Connect to Drive
dialog box appears.
2.
Click
WHO
.