GETTING STARTED Owner manual

7-10 Setting Up ControlNet Direct Communications
Setting Up Communications in a DriveTools32 Application
Before a DriveTools32 application can communicate with a drive, you must
configure the application. To do this, you need to:
1.
Start the DriveTools32 application.
2.
In the
Options
menu, select
Communication Setup
. The
Communication
Setup
dialog box appears.
3.
Click the
ControlNet
tab.
4.
Under
Connect Type
, select
KFC to ControlNet Phase 1.5 Direct
.
5.
In the
Enter INTERCHANGE Port Mapping #
field, type the number of
the KT:0 port used by the ControlNet driver in the RSLinx
Configure
Client Applications
dialog box.
Important:
To view the KT Port number used by the DF1 driver, select
Configure Client Applications
in the RSLinx
Communications
menu.
6.
If you are using a 1336 FORCE and its drive firmware version is 0.10,
select
1336T Two Word Header (used ONLY for 1336T version 0.10)
.
7.
Click
OK
.