GETTING STARTED Owner manual

Setting Up DH+ to RIO Block Transfer Pass Thru Communications 6-5
5.
In the
Enter INTERCHANGE Port Mapping #
field, type the number of
the KT:0 port used by the DH+ driver in the RSLinx
Configure Client
Applications
dialog box.
Important:
To view the KT Port number used by the DH+ driver, select
Configure Client Applications
in the RSLinx
Communications
menu.
6.
If you are using a 1336 FORCE and its drive firmware version is 0.10,
select
1336T Two Word Header (used ONLY for 1336T version 0.10)
.
7.
Click
OK
. The following prompt appears.
8.
Read the information, and then click
OK
.
Connecting to the Drive
After configuring RSLinx and the DriveTools32 application, you are ready to
connect to a drive.
1.
In the
Drive
menu, select
Connect to Drive
. The
RIO Pass Through
Network Connect to Drive
dialog box appears.