GETTING STARTED Owner manual

Setting Up RS-232 Point-to-Point Serial Communications 3-5
12.
Click
OK
to save the configuration. The new driver appears in the
Configure Drivers
dialog box.
13.
Click
Close
.
Mapping the Configured Driver to the KTPort Value
After configuring the driver, you must map it to a legacy INTERCHANGE API
xKT:0 label in RSLinx so that DriveTools32 can use it.
1.
In the
Communications
menu, select
Configure Client Applications
. The
Configure Client Applications
dialog box appears.
2.
In an unused
KT:0
field, select the DF1 device.
Important:
Note the KT:0 field that you select. When you configure a
DriveTools32 application, you need to enter the field number in the
Communication Setup
dialog box.
3.
Click
OK
to map the driver to the KT:0 value.