GETTING STARTED Owner manual

11-6 Using RSLinx Gateways
Setting Up
Communications
in a DriveTools32
Application
Before a DriveTools32 application can communicate with a drive, you must
configure the application. To do so, you need to:
1.
Start the DriveTools32 application.
2.
In the
Options
menu, select
Communication Setup
. The
Communication
Setup
dialog box appears.
3.
Click the
RSLinx Gateway
tab.
4.
Under
Connect Type
, select the appropriate communications type.
If your Gateway is to: Select:
ControlNet To ControlNet Direct
DH+ Direct To DH+ Direct
DH+ to RIO Block Transfer Pass Thru To DH+ to PLC RIO Pass-Thru
Serial To RS-232 SCANport Point to Point Serial