GETTING STARTED Owner manual

10-2 Setting Up Allen-Bradley Ethernet to RIO Block Transfer Pass Thru Communications

Figure 10.1 shows an example:

Figure 10.1

Allen-Bradley Ethernet Communications

Hardware

Required Hardware

The hardware required for this type of communications depends on the drive

type. Refer to the following table:

SCANport-

Compatible

Product

1395

Drive

1336

FORCE

Drive

PLC-5E

RIO

Ethernet

Important:

In the Remote I/O

communications module, Switch 1 of SW3

must be On to enable block transfer.

Drive Required Drive Hardware Required Computer Hardware

SCANport Product

➀

Remote I/O adapter (1203-GD1,

1203-GK1, or 1336-GM1) and

appropriate cable(s)

Ethernet Interface Running TCP/IP

Protocol

1336 FORCE PLC Communications Board

(1336T-GT1EN)

Ethernet Interface Running TCP/IP

Protocol

1395 Node Adapter (1395-KP50) or

Multi-Communications Adapter

(1395-KP51)

Ethernet Interface Running TCP/IP

Protocol

➀

For a list of SCANport-compatible products, refer to Appendix A,

Products Supported by DriveTools32