User guide

Publication 900-UM007D-EN-E - January 2011
B-14
➊ Set “None” as the unit for analog inputs (23: 0 to 50 mV).
➋ The setting range depends on whether control output 1 is a current output or voltage output (for driving SSR).
➌ P.END (program end output) can be configured even when the program pattern is configured to OFF, but the
function will be disabled.
➍ Turns ON when either the control output 1 or 2 ON/OFF count alarm is ON.
Control Output 2 ON/
OFF Count Alarm Set
Value
ra2 0....9999 0 100 times
ON/OFF Counter Reset rac
0: Disable the counter reset
function.
1: Reset the control output 1
ON/OFF counter.
2: Reset the control output 2
ON/OFF counter.
o None
Move to Calibration
function group
cmov −1999…9,999 0 None
Table B.F — Advanced Setting Function Group
Parameters Characters Setting (Monitor) Value Display Default Unit Set Value
Table B.G — Protect Function Group
Parameters Characters Setting (Monitor) Value Display Default Unit Set value
Move to Protect function
group
pmov −1999…9,999 0 None
Operation/Adjustment
Protect
oapt 0…3 0 None
Initial
Setting/Communications
Protect
icpt 0…2 1 None
Setting Change Protect wtpt OFF, ON off on OFF None
PF Key Protect pfpt OFF, ON off on OFF None
Parameter Mask Enable pmsk OFF, ON off on ON None
Password to Move to
Protect function group
prlp −1999…9,999 0 None
Table B.H Communications Function Group
Parameters Characters Setting (monitor) value Display Default Unit Set value
Protocol Setting psel 900-TC, Modbus cwf
mod
900-TC None
Communications Unit
No.
u-no 0…99 1 None
Communications Baud
Rate
bps 1.2, 2.4, 4.8, 9.6, 19.2, 38.4, or
57.6
1.2 2.4
4.8 9.6
19.2 38.4
57.6
9.6 kbps
Communications Data
Length
len 7, 8 7 Bit