User guide

Publication 900-UM007D-EN-E - January 2011
B-8
➍ Initialized when the transfer output type is changed.
Initialized if the Input Type, temperature unit, scaling upper/Lower-Limit, or SP upper/Lower-Limit is changed
when the transfer output type is SP, ramp SP, or PV.
(When initialized by the initializing settings, it is initialized to 100.0/0.0.)
➎ When the Manual MV Limit Enable parameter is configured to ON, the setting range will be the MV lower limit
to the MV upper limit
Extraction of Square
Root Enable
sqr OFF, ON off
on
OFF None
Move to Advanced
Setting function group
amov −1999…9,999 0 None
➊Set “None” as the unit for analog inputs
➋Initial Setting function group
➌PRST (Program Start) can be configured even when the Program Pattern parameter is configured to OFF, but the function will be disabled.
Table B.C — Initial Setting Function Group
Parameters Characters Setting (Monitor) Value Display Default Unit Set Value
Table B.D
Transfer Output Type Setting (Monitor) Range
Default (Transfer Output
Upper/Lower-Limits) ➍ Unit
Set Point SP Lower-Limit to SP Upper-Limit SP Upper-Limit/Lower-Limit EU
Set Point During SP Ramp SP Lower-Limit to SP Upper-Limit SP Upper-Limit/Lower-Limit EU
PV Temperature: Sensor setting range Lower-Limit
to sensor setting range Upper-Limit
Input setting range upper/Lower-Limit EU
Analog: Scaling Lower-Limit to scaling
Upper-Limit
Scaling upper/Lower-Limit EU
MV Monitor (Heating) Standard: −5.0…105.0
Heating/cooling: 0.0…105.0
100.0/0.0 %
MV Monitor (Cooling) 0.0…105.0 100.0/0.0 %
Table B.E — Manual Control Function Group
Parameters Characters Setting (Monitor) Value Display Default Unit Set Value
Manual MV −5.0…105.0 (standard)
➎
−105.0…105.0 (heating/cooling)
0.0 %