User guide

Publication 900-UM007D-EN-E - January 2011
B-7
Table B.C — Initial Setting Function Group
Parameters Characters Setting (Monitor) Value Display Default Unit Set Value
Alarm 2 Type alt2 Same settings as the alarm 1 type.
NOTE: The 12: LBA (Loop Burnout
Alarm) setting cannot be used.
2 None
Alarm 2 Hysteresis alh2 Universal input: 0.1…999.9 0.2 °C or °F ➊
Analog input: 0.01…99.99 0.02 %FS
Alarm 3 Type alt3 Same settings as the alarm 2 type 2 None
Alarm 3 Hysteresis alh3 Universal input: 0.1…999.9 0.2 °C or °F ➊
Analog input: 0.01…99.99 0.02 %FS
Transfer output type tr-t OFF:OFF
SP:Set point
SP-M:Ramp set point
PV:Process value
MV:Manipulated variable (heating)
C-MV:Manipulated variable (cooling)
off
sp
sp-m
pv
mv
c-mv
OFF None
Transfer Output
Upper-Limit
tr-h ➋➋➋
Transfer Output
Lower-Limit
tr-l ➋➋➋
Linear Current Output o1-t 4-20: 4…20 mA
0-20: 0…20 mA
4-20
0-20
4-20 None
Number of Multi-SP
Uses
ev-m 0…2 1 None
Event Input
Assignment 1
ev-1 NONE: None
STOP: RUN/STOP
MANU: Auto/manual switch
PRST: Program start ➌
DRS: Invert Direct/Reverse Operation
AT-2: 100% AT Execute/Cancel
AT-1: 40% AT Execute/Cancel
WTPT: Setting Change Enable/Disable
LAT: Alarm Latch Cancel
none
stop
manu
prst
drs
at-2
at-1
wtpt
lat
NONE None
Event Input
Assignment 2
ev-2 NONE: None
STOP: RUN/STOP
MANU: Auto/manual switch
PRST: Program start ➌
DRS: Invert Direct/Reverse Operation
AT-2: 100% AT Execute/Cancel
AT-1: 40% AT Execute/Cancel
WTPT: Setting Change Enable/Disable
LAT: Alarm Latch Cancel
none
stop
manu
prst
drs
at-2
at-1
wtpt
lat
STOP None