User guide

Publication 900-UM007D-EN-E - January 2011
Parameter Functions & Definitions 5-67
Function: The following functions can be assigned to event inputs 1 and 2:
•RUN/STOP
• Auto/Manual Switch
•Program Start
• Invert Direct/Reverse Operation
• 100% AT Execute/Cancel
• 40% AT Execute/Cancel
• Setting Change Enable/Disable
• Alarm Latch Cancel
Default:
• Event Input Assignment 1:
none
• Event Input Assignment 2: stop.
Note: 1 PRST (Program Start) can be configured even when the Program Pat-
tern parameter is configured to OFF, but the function will be dis-
abled.
Note: 2 This function can be configured for heating/cooling control, but the
function will be disabled.
Related Parameters
• SP0 to SP3 (Adjustment function group, page 5-33)
• Number of multi-SP uses (Initial Setting function group, page 5-65)
Table 5.CC
Selection Function
none None
stop RUN/STOP
manu Auto/Manual
prst Program start (see note 1.)
drs Invert Direct/Reverse Operation
at-2 100% AT Execute/Cancel
at-1 40% AT Execute/ Cancel (see note 2)
wtpt Setting Change Enable/Disable
lat Alarm Latch Cancel