User guide

Publication 900-UM007D-EN-E - January 2011
Parameter Functions & Definitions 5-39
Related Parameters
• PID ON/OFF, Standard or Heating/Cooling (Initial Setting function
group, page 5-55)
Soak Time
Conditions of Use: The Program Pattern parameter must NOT be set to
OFF.
Function: This parameter enables you to configure the soak or delay time for
the control operation when using the simple program function.
Related Parameters
• Program Start, Soak Time Remain (Operation function group, page
5-15)
• Wait Band (Adjustment function group, page 5-40)
• Program Pattern (Initial Setting function group, page 5-57)
• Soak Time Unit (Advanced Setting function group, page 5-96)
Table 5.AQ
Parameters Controller Type
Configurable
Range Units Default
Hysteresis (heating) With Thermocouple or Resistance Thermometer (RTD) 0.1…999.9 °C or °F ➊ 1.0
With Analog Inputs 0.01…99.99 %FS 0.10
Hysteresis (cooling) With Thermocouple or Resistance Thermometer (RTD) 0.0…999.9 °C or °F ➊ 1.0
With Analog Inputs 0.01…99.99 %FS 0.10
➊ Set NONE as the unit for Controllers with 0…50 Millivolt Inputs.
Table 5.AR
Configurable Range Units Default
1…9999 Minutes or hours 1
soak