User guide

Publication 900-UM007D-EN-E - January 2011
4-84 Parameter Adjustments & Application Considerations
table shows the details of the settings. For setting (monitor) ranges, refer to
applicable parameter.
Note: For details on MV settings for heating and cooling control, refer to MV Display for
Heating and Cooling.
Configuring Monitor/Setting Items
Pressing the PF Key in wither the Operation or Adjustment function group
displays the applicable monitor/settings items. Press the PF Key to display in
order Monitor/Setting items 1 to 5. After Monitor/Setting Item 5 has been
displayed, the display will switch to the top parameter in the Operation
function group.
1. Items configured as disabled in the Monitor/Setting Items 1 to 5
parameters will not be displayed, and the display will skip to the next
enabled item.
2. While a monitor/setting item is being displayed, the display will be
switched to the top parameter in the Operation function group if the M
Key or the O Key is pressed.
Table 4.AM — Setting Detail
Set Value Operation/Function
Remarks
SymbolMonitor/Setting
0 Disabled ---
1 PV/SP/Multi-SP Can be configured. (SP) ---
2 PV/SP/MV (see note) Can be configured. (SP) ---
3 PV/SP/Soak time remain Can be configured. (SP) ---
4 Proportional band (P) Can be configured. p
5 Integral time (I) Can be configured. c
6 Derivative time (D) Can be configured. d
7 Alarm value 1 Can be configured. al-1
8 Alarm value upper limit 1 Can be configured. al1h
9 Alarm value lower limit 1 Can be configured. al1l
10 Alarm value 2 Can be configured. al-2
11 Alarm value upper limit 2 Can be configured. al-2h
12 Alarm value lower limit 2 Can be configured. al-2l
13 Alarm value 3 Can be configured. al-3
14 Alarm value upper limit 3 Can be configured. al3h
15 Alarm value lower limit 3 Can be configured. al3l