User guide

Publication 8720MC-IN002A-EN-P — December 2002
1-10 Commissioning Your 8720MC SERCOS Interface Drive
17. Select your 8720MC-xxxx drive.
18. Select OK. The Module Properties window opens.
19. Provide/select the following Module Properties attributes:
• Module name
• Base Node address
• Electronic Keying option
20. Select Next until the following window opens.
21. Select the New Axis button. The New Tag window opens.
22. Provide/select the following New Tag attributes:
•Axis name
• AXIS_SERVO_DRIVE as the Data Type
23. Assign your axis to the node address (as shown in the window
below).
24. Select Next.