User guide

Publication 8720MC-IN002A-EN-P — December 2002
B-16 Using the Human Interface Module (HIM)
Programming a Password When Drive Power is Applied
With a Series B remote HIM, you can program Password mode to be
displayed when drive power is applied. To do this, you need to press
the Increment and Decrement keys simultaneously while the
Password display is shown.
Once you set the password, the Program/EEProm modes and the
Control Logic/Clear Queue menus are password protected and are not
displayed in the menu. To access these modes, you need to:
1. Press any key from the status display. Choose Mode is shown.
2. Press the increment up or decrement down keys to show
“Password.”
3. Press the enter key. “Enter Password” is displayed.
4. Press the increment up or the decrement down key until the
correct password digit is displayed. The select key can be used to
move the cursor from digit to digit.
5. When the correct password number is displayed press enter
You can now access the Program and EEProm modes.
Logging Out
To prevent future access to program changes, you need to logout:
1. Press any key from the status display. “Choose Mode” is shown.
2. Press the increment up or the decrement down key to show
“Password”.
3. Press enter
4. Press the increment up or the decrement down key until “Logout”
is displayed.
5. Press enter to log out of Password mode.