Software

4–4 Configuring ODS
Publication MCD-5.1 -August 1999
If your are using Windows NT, ODS allows you to select your
default printer from a list of printers that are currently available to
your system. Use the
[F5]–Configuration pulldown menu to access
Print device setup.
Use this procedure to select your print device:
1. Select the
Print device setup option from the
[F5]–Configuration menu. The following list box appears:
Select the appropriate baud rate for your serial communication
device. To abort this activity, select
<ESC>.
2. Select the appropriate print port for system. A checkmark
appears next to the current active choice. After you select a print
device, ODS saves it and makes this the default printer whenever
ODS is started. To cancel this selection, press
<ESC>.
ODS has a beeper that warns you when you press an illegal key or
when you attempt something that is not allowed. The
F5-Configuration menu lets you decide whether or not to use the
beeper.
Use this procedure to set the beeper:
1. Select [
F5] and pull down the F5-Configuration menu.
You can set the beeper to ON or OFF. A checkmark appears next
to the current active choice. If this is the first time ODS has been
configured, the check is next to
Beeper ON. After you make a
choice, ODS saves it and puts the beeper in that state whenever
ODS is started.
2. Select either
Beeper ON or Beeper OFF.
The configuration menu disappears, but the beeper is set
according to the choice you made.
Configuring Print Device
(Windows NT only)
Turning the Beeper
ON/OFF