Owner's manual

OffsetTable and Setup
Chapter 3
3-25
4. Use the up, or down cursor keys t o move the block cursor to the
feedrate parameter to be changed. The selected feedrate will be
shown in reverse video.
5. There are two c hoices for changing feedrate values.
Type in a new value for the selected feedrate by using the keys on
the operator panel. Then press the
{REPLCE VALUE} softkey. The
value typed in will replace the old value for that feedrate.
Type in a value to add to the old value for the selected feedrate by
using the keys on the operator panel. Then press the
{ADD TO VALUE} softkey. The value typed in will be added to the
old value for that feedrate.
(softkey level 4)
REPLCE
VALUE
ADD TO
VALUE
UPDATE
& EXIT
QUIT
6. To leave the feedrate parameter screen there are two choices.
To save the changes just made and leave the feedrate parameter
screen press the
{UPDATE & EXIT} softkey.
To leave the feedrate parameter screen without saving the changes
press t he
{QUIT} softkey.
(softkey level 4)
REPLCE
VALUE
ADD TO
VALUE
UPDATE
& EXIT
QUIT
END OF CHAPTER