Owner's manual

OffsetTables and Setup
Chapter 3
3-22
Figure 3.7
Programmable Zone Table
ENTER VALUE:
PROGRAMMABLE ZONE
LOWER LIMIT UPPER LIMIT
LIMIT 2
X AXIS 0.0000 0.0000 [ MM ]
Y AXIS 0.0000 0.0000 [ MM ]
Z AXIS 0.0000 0.0000 [ MM ]
U AXIS 0.0000 0.0000 [ MM ]
REPLCE
VALUE
ADD TO
VALUE
MORE
LIMITS
UPDATE
& EXIT
QUIT
Important: Programmable z one coordinates are displayed in inch or
metric units for a liner axis, depending on which is the currently active
program mode. Rotary axes are shown in units of degrees.
4. Use the up or down cursor keys to move the block cursor to the data
to be changed. Data located at the cursor-will be shown in reverse
video.