Owner's manual

OffsetTable and Setup
Chapter 3
3-21
The programmable zone feature provides a means t o prevent tool motion
from entering or exiting a designated area. For details on programmable
zones see chapter 12.
This table c ontains the values for programmable zones 2 and 3. These
values define the boundaries for the programmable zones a nd are
referenced from the machine coordinate system.
Important: These values may also be entered in AMP by the system
installer. Programmable zone 3 table values may also be modified by
programming a G22 command (see chapter 12).
1. To display or alter the values in the programmable zone table follow
the steps below:
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
QUICK
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2. Press the {PROGRAM PARAM} softkey.
(softkey level 2)
PRGRAM
PARAM
AMP DEVICE
SETUP
MONI-
TOR
TIME
PARTS
PTOM
SI/OEM
3. Press t he {ZONE LIMITS} softkey to display the programmable
zone table as shown i n Figure 3.7.
(softkey level 3)
ZONE
LIMITS
F1-F9 MILCYC
PARAM
PROBE
PARAM
3.5
Programmable Zone Table