Owner's manual

Allen-Bradley 7300 Series CNC
Tape Compatibility
Appendix D
D-10
Table D.C (continued)
Mill G-codes Available in 7300 Mode
G-code: Description:
G49 Tool lengthcancel
G52 Offsetcoordinatezeropoint
G53 Motion inmachine coordinate system
G54 Presetwo rk coordinatesystem1
G55 Presetwo rk coordinatesystem2
G56 Presetwo rk coordinatesystem3
G57 Presetwo rk coordinatesystem4
G58 Presetwo rk coordinatesystem5
G59 Presetwo rk coordinatesystem6
G61 Exactstop mode
G62 Automaticcorner override
G63 Tapping mode
G64 Cutting mode
G65 Paramacro call
G66 Paramacro modalcall
G67 Paramacro modalcancel
G68 Partrotation
G69 Partrotation cancel
G92 Coordinate offsetusing tool positions
G95 F eed perrevolutionmode
The control does not support these 7300 Series CNC features:
7300 Scaling (using “SCF”with G-codes)
7300 Part Rotation
Additional Plane Selection (beyond G17, G18 and G19)
7300 Tool Axis Switching
7300 Cutter Compensation Entry and Exit Motion
All cutter compensation m oves, except for the entry and exit moves
,usethe
same paths for 7300 and control. However, the e ntry and exit moves of cutter
compensation uses the control’s tool paths. Refer to chapter 21 for details.
END OF APPENDIX
7300 Series Features Not
Supported