Owner's manual

Allen-Bradley 7300 Series CNC
Tape Compatibility
Appendix D
D-9
The main program, which has the pattern repeat call block “(CP, name, r)”,
can be executed from tape or from the control’s memory. However, if you
want to make minor editing to your main program, you must copy the
program into the c ontrol’s memory. Refer to Section 9.2, “Inputting Part
Programs,”for details on how to copy a program from tape.
Important: To execute a program from tape, the tape must be positioned
at the start of the main program.
For more information on how subprograms are executed in the control,
refer to chapter 10, “Subprogram C all (M98).”
You may enhance your 7300 part program flexibility with selected 9/Series
features. Table D.C lists the control’s G-codes that can be executed in
7300 mode. However, we recommend that you use t he 9/Series
programming method for optimal performance. Refer to earlier sections of
this manual for details on these G-codes.
Table D.C
Mill G-codes Available in 7300 Mode
G-code: Description:
G09 Exact stop
G10L2 Setup work coordinate offsettable
G10L3 Setup tool managementtable
G10L10 Setuptooloffsetgeometry table
G10L11 Setuptooloffsetweartable
G10L12 Setuptooldiameterweartable
G10L13 Setuptooldiametergeometrytable
G11 Setup tool managementtablecancel
G14 Disable scaling
G27 Machinehomereturn check
G28 Automaticreturntohome
G29 Automaticreturnfromhome
G30 Return to secondary home
G31 External skip function 1
G36 ShortblockAcc/Decdisabled
G37 Tool gauging skip function1
G38 Hole probing
G39 Cuttercompensation (lineartransition)
G43 Tool lengthplus
G44 Tool lengthminus
9/Series G-codes Applicable
to the 7300 Series CNC