Owner's manual

G-codeTables
Appendix C
C-4
A TypeFunctionModal Group
G66.1 Paramacro ModalCall
G67 Paramacro ModalCall(Cancel)
G68 16 Part Rotation Modal
G69 PartRotation (Cancel)
G73 09 Deep Hole PeckDrilling Cycle (With dwell) Modal
G74 Left-HandTappingCycle
G74.1 Left-Hand Solid Tapping Cycle
G76 BoringCycle(Spindle Shift)
G80 Cancel orEnd FixedCycle
G81 09 Drilling Cycle (No Dwell,Ra pid Out) Modal
G82 Drilling Cycle (Dwell,Rapid Out)
G83 Deep Hole PeckDrilling Cycle
G84 Right-Hand TappingCycle
G84.1 Right-HandSolidTapping Cycle
G85 Bo ring Cycle (No Dwell,Feed Out)
G86 BoringCycle(Spindle Stop,RapidOut)
G87 Back Boring Cycle
G88 BoringCycle(Spindle Stop,ManualOut)
G88.1 00 PocketMillingRoughing Cycle Non--Modal
G88.2 PocketMilling Finishing Cycle
G88.3 PostMillingRoughing Cycle
G88.4 PostMilling Finishing Cycle
G88.5 Hemispherical Milling (RoughingCycle)
G88.6 Hemispherical Milling (FinishingCycle)
G89 09 BoringCycle(WithDwell,FeedOut) Modal
G89.1 00 IrregularPocketMilling(Roughing Cycle) Non--Modal
G89.2 IrregularPocketMilling(Finishing Cycle)
G90 03 Absolute Mode Modal
G91 IncrementalMode
G92 00 Coordinate SystemOffset(Using ToolPositions) Non-Modal
G92.1 CoordinateSystemOffset(Cancel)
G92.2 Selected Coordinate SystemOffsets (Cancel)
G93 05 Inverse TimeFeed Mode Modal
G94 F eed-per-minute mode
G95 F eed-per-revolution Mode
G98 10 Initial Level Returnin MillingCycles Modal
G99 R-Point Level Returnin Milling Cycles
END OF APPENDIX