Owner's manual

Appendix
C
C-1
G-code Tables
This appendix lists the G-codes for 9/Series Mill controls. They are listed
numerically along with a brief description of their use. These G-codes are
discussed in detail in the sections within this manual that refer to their
specific usage.
The group numbers given in the table refer to modality. Group 00 are not
modal and are independent of other G-codes. The remaining G-code
groups are m odal with other G-codes with the same group number. This
means programming a G-code in group 1 replaces any other active group 1
G-code but does not affect any G-codes in the other group numbers.
A ModalGroup Function Type
G00 01 Rapid Positioning Modal
G01 Linear Interpolation
G02 Circular/HelicalInterpolation (Clockwise)
G03 Circular/HelicalInterpolation (Counterclockwise)
G04 00 Dwell Non-Modal
G05 Send Commandand Waitfor ReturnStatus(for9/SERIES
Data Highway Communication Module)
N
o
n
-
M
o
d
a
l
G05.1-G05.4 SendCommand withoutWaitingforReturnStatus
(for9/SERIES DataHighwayCommunication Module)
G09 Exact Stop
G10L2 Setup WorkCoordinate OffsetTables
G10L3 Setup Tool ManagementTable
G10L10 Setup ToolLengthValuesGeometryTable
G10L11 Setup ToolLengthValuesWearTable
G10L12 Setup ToolRadiusValuesGeometryTable
G10L13 Setup ToolRadiusWearValuesWearTable
G10.1 Setup RandomToolTable
G10.2L1 Communication Configuration Information (for9/SERIESData
HighwayCommunication Module)
G10.2L2 OutputCommandTable(for9/SERIES Data Highway
Communication Module)
G10.2L3 DownloadConfiguration Information (for9/SERIESData
HighwayCommunication Module)
G11 Setup Tool ManagementTable(Cancel)
Appendix Overview
G-code Tables