Owner's manual

9/Series PAL Reference Manual
Index (General)
9/Series Mill
Table of Contents
Operation and Programming Manual
v
10.4.1 Minimum and Maximum Axis Motion (Programming Resolution) 10-21.....................
10.5 Word Descriptions 10-22.........................................................
10.5.1A_ L_,R_ ,C_ (Quic k Plus and Radius-Chamfer Words) 10-22..........................
10.5.2AxisNames 10-22.........................................................
10.5.3D --and H--Words (ToolOffsets) 10-22............................................
10.5.4 F--words (Feedrate) 10-23....................................................
10.5.5G--codes (Preparatory Functions) 10-24..........................................
10.5.6I,J,and K IntegrandWords 10-30.............................................
10.5.7M -- codes(Miscellaneous Functions) 10-30........................................
10.5.7.1 Auxiliary Miscellaneous Function(B--word) 10-37..................................
10.5.8N --words(SequenceNumbers) 10-37............................................
10.5.9O--words(ProgramNames) 10-37..............................................
10.5.10P ,L (MainProgramJumps andSubprogramCalls) 10-37.............................
10.5.11 S-- word (Spindle Speed) 10-38................................................
10.5.12T--words (ToolSelection) 10-40................................................
Chapter 11
Coordinate Systems Offsets
11.0Chapter Overview 11-1.........................................................
11.1 Machine Coordinate System(Absolute) 11-1..........................................
11.1.1 MotionintheMachine Coordinate System(G53) 11-2.................................
11.2PresetWorkCoordinateSystems (G54-59.3) 11-4......................................
11.2.1 AlteringWork Coordinate Systems(G10L2) 11-7....................................
11.3Work Coordinate SystemExternalOffset 11-9.........................................
11.3.1 AlteringExternal Offs et (G10L2) 11-11............................................
11.4Offsetting the WorkCoordinateSystems 11-13..........................................
11.4.1CoordinateOffsetUsing ToolPosition (G92) 11-13....................................
11.4.2 Offsetting Coordinate Zero Points(G52) 11-16.......................................
1 1.4.3 {SET ZERO} Offset 1 1-18.....................................................
11.4.4 Jogging an Offset 11-19.......................................................
11.4.5 Canceling Coordinate SystemOffsets (G92.1) 11-20..................................
11.4.6 Canceling SelectedCoordinateSystem Offsets (G92.2) 11-21..........................
1 1.5 P AL Offsets 11-22..............................................................
Chapter 12
Overtravels and Programmable Zones
12.0 Chapter Overview 12-1.........................................................
12.1 Hardware Overtravels 12-2......................................................
12.2 Software Overtravels 12-3.......................................................
12.3 Programmable Zone2 (G22,G23) 12-5..............................................
12.4 Programmable Zone3 (G22.1, G23.1) 12-7...........................................
12.5 Resetting Overtravels 12-13.......................................................