Owner's manual

Softkey Tree
Appendix A
A-3
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
Ifyou want to: Press:
Edit,activate,orcopyaprogramfromaperipheral orcontrolmemory
{PRGRAM MANAGE}
Display orentertool offsetdata,the workcoordinate system offsetdata,etc.
{OFFSET}
Viewandmodifythelocalandglobalparameterassignmentsforparamacros
{MACRO PA RAM}
Check the partprogram,graphics,QuickCheck, andactive programwithout
actually movingan axis
{PRGRAM CHECK}
Enter and display inhibit zone limits, canned cycle parameter data,
communications,AMP,etc.
{SYSTEM SUPORT}
Perform various operations that would normally be done by using an MTB
panel,cyclestart,jogging,etc.
{FRONT PANEL}
Display errormessages,includingan errorlog ofold messages
{ERROR MESAGE}
Enterorassign passwordsand access levels to selectedfeatures
{PASSWORD}
Changethelanguage displayed onthescreenofthe control
{SWITCH LANG}
Display more softkeys on the same level when there are more softkeys on
a level than canbe displayed atonce
{• }
Display the previous level orprevious row ofsoftkeys {• }
The remainder of this appendix shows the softkey tree. This tree illustrates
the entire softkey layout on the control i n an easy-to-use flow-chart type
format. This flow chart has been drawn to have no 4-way intersections (no
4 lines connected at any one point). If you see what appears to be a 4-way
intersection, it is really only a crossover point for lines that do not
intersect.
DescribingLevel1 Softkeys
Using the Softkey Tree