Owner's manual

OffsetTable and Setup
Chapter 3
3-11
Your system installer initially sets these values in AMP. You can modify
them with online AMP by using this screen:
REPLCE
VALUE
ADD TO
VALUE
UPDATE
& EXIT
QUIT
MAXIM UM+/-- WEARRADIUS
MAXIM UM+/-- GEOM RADIUS
MAXIM UMWEAR OFFSET CHANGE
MAXIM UMGEOM OFFSET CHANGE
MAXIM UM+/-- WEAROFFSET
MAXIM UM+/-- GEOM OFFSET
NEXT
AXIS
OFFSET RANGE VERIFICATION
Pertable values
Peraxisvalues
[inch]
.12345
10.12345
[inch]
.01000
1.00000
.10000
10.00000
softkey level 5
About the Offset Range Verification Screen
display format is fixed
Mode Placesto the left of the decimalpoint Places to the righ t of th e decimal point
inch 3 5
metric 4 5
data entry is bounded by the programming resolution of the axes
When Does Verification Occur
Verification occurs when a value enters the table from:
• data entry screens • PAL • paramacros
Important: The c ontrol does not perform the verification if the value, old
or new, is zero, nor does i t check G10 data-setting codes.