Owner's manual

Using Transfer Line Cycles
Chapter 31
31-39
Template 10: Boring Cycle, Spindle Stop/Rapid Out
Letter Paramacro Label Description
G 500
G90/91 G-codesG90 orG91forabsolute orincremental modes. Atthis timeonly absolute
mode,G90,is available.
X,Y 501, 502
HOLE POSITION X, Y The location towhich thetoolmovesbefore it begins aboringoperation.
X 503
DEPTH OF HOLE The locationtowhichthetoolboresinto the part.
R 504
CLEAR POSITION The locationthatthe tool retracts to afteranoperation.Itiscompletelyfree of the
part.Thisalso known astheR plane.
X,Y 505, 506
RETURN POSITION X,Y The location wherethe controls starts and stops a cycle.
F 507
FEEDRATE The feedrate fordrilling/boring operations,andallmovesrepresented bythesolid
linesintheQuickViewscreens. This is also the maximumfeedrateforoperations
that use adaptive depth.
P 508
AMOUNT OF DWELL T he amountoftime the axispausesbefore itretractsfromthehole;measured in
seconds.
X 509
TOOL CHANGEPOSITION The location the controlmoves to sothatatoolchangemaybe performed.
I 510
HARD STOP SENSE ZONE Once itreaches thislocation,thecontrol knows to expect a hardstop before
reaching the holebottom.
I 511
ADAPTIVE DEPTH
INCREMENT
The amountofdistance thatthecontrol willincrementthetoolinto the partduringan
adaptive depth operation.
M 512
M03/M04 The M-- code usedtoturn the spindle clockwise or counter-clockwise.
S 513
SPINDLE SPEED The speedofthe spindle.Measuredin revolutions per minute.
Required entry Optional entry