Owner's manual

Using Transfer Line Cycles
Chapter 31
31-38
Template 9: Boring Cycle, No Dwell/Feed Out
Letter Paramacro Label Description
G 500
G90/91 G-codesG90 orG91forabsolute orincremental modes. Atthis timeonly absolute
mode,G90,is available.
X,Y 501, 502
HOLE POSITION X, Y The location towhich thetoolmovesbefore it begins aboringoperation.
X 503
DEPTH OF HOLE The locationtowhichthetoolboresinto the part.
R 504
CLEAR POSITION The locationthatthe tool retracts to afteranoperation.Itiscompletelyfree of the
part.Thisalso known astheR plane.
X,Y 505, 506
RETURN POSITION X,Y The location wherethe controls starts and stops a cycle.
F 507
FEEDRATE The feedrate fordrilling/boring operations. This isalso the maximumfeedratefor
operationsthatuseadaptive depth.
X 508
TOOL CHANGEPOSITION The location the controlmoves to sothatatoolchangemaybe performed.
I 509
HARD STOP SENSE ZONE Once itreaches thislocation,thecontrol knows to expect a hardstop before
reaching the holebottom.
I 510
ADAPTIVE DEPTH
INCREMENT
The amountofdistance thatthecontrol willincrementthetoolinto the partduringan
adaptive depth operation.
M 511
M03/M04 The M-- code usedtoturn the spindle clockwise or counter-clockwise.
S 512
SPINDLE SPEED The speedofthe spindle.Measuredin revolutions per minute.
Required entry Optional entry
Figure 31.12
Boring Cycle (Without Dwell, Feed Out)
1
2
3
4
C
u
t
t
i
n
g
f
e
e
d
r
a
t
e
Maximum cutting feedrate
Depth of Hole
Clear Position
Hole Position
Return
Position