Owner's manual

Using Transfer Line Cycles
Chapter 31
31-26
Template 1: Drilling Cycle, No Dwell/Rapid Out
Letter Paramacro Label Description
G 500
G90/91 G-codesG90 orG91forabsolute or incrementalmodes. Atthis timeonly absolute
mode,G90,is available.
X,Y 501, 502
HOLE POSITION X, Y The locationtowhich the tool moves beforeitbegins adrillingoperation.
X 503
DEPTH OF HOLE The location to which thetool drillsinto the part.
R 504
CLEAR POSITION The locationthetoolretractstoafteran operation.Itiscompletelyfree ofthe part.
Thisalso known astheR plane.
X,Y 505, 506
RETURN POSITION X,Y The location wherethe controls starts and stops acycle.
F 507
FEEDRATE The cutting feedratefordrilling/boring operations. T his isalso the ma ximumfeedrate
for operationsthatuse adaptive depth.
X 508
TOOL CHANGEPOSITION The locationatwhichyou canperformatoolchangeoperation.
E 509
ADAPTIVE FEED MINIMUM T his isthe minimumfeedrateatwhichthe controlperformsan adaptivefeed
operation.The control will trytomaintainthisminimumfeedrate,even ifitmeans
increasing the adaptivefeedtorque percent.
Q 510
ADAPTIVE FEED TORQUE % This is the amountoftheselected servo’s continuousrated torque asentered in
AMP byyoursysteminstaller. Valid ranges are from1 to 150% oftheservo’srated
torque. Refer to yoursysteminstaller’sdocumentationfordetailson the ratedtorque
ofthe servosin yoursystem.
Important:Thetorque amountapplied bytheservo isnotthecuttingforce. Itisthe
torque applied bytheservotothe axis. You mustcalculatetheequivalentcutting
force based onyourmachinedynamics (motor ratedtorque,lead screwpitch,
gearing,tooldimensions,etc...).
I 511
HARD STOP SENSE ZONE Onceitreaches thislocation,thecontrol knows to expectahardstopbefore
reaching the holebottom.
I 512
ADAPTIVE DEPTH INCREMENT The amountofdistancethatthe control will incrementthe tool intothepartduring an
adaptive depth operation.
M 513
M03/M04 TheM--codeused to turnthespindleclockwise orcounter-clockwise.
S 514
SPINDLE SPEED The speedofthespindle.Measuredin revolutions perminute.
Required entry Optional entry