Owner's manual

Using Transfer Line Cycles
Chapter 31
31-16
Changing the Program with the Part Program Edit or
You can change program generated by QuickView with the part program
editor. To learn how to use the part program editor, refer to the appropriate
chapter in this manual. The changes you make to to the part program will
be specific to that part program and will not change the templates. The
templates a re kept in the protected directory, and are used by QuickView
every time it generates a program.
This table lists special M codes that are used to communicate with the
control’s PAL program and with Allen Bradley remote I/O.
Table 31- B
Standard T-Line-9 M codes
Mcodes Description:
M90 TransferClear
M91 TransferNot Clear