Owner's manual

Using Transfer Line Cycles
Chapter 31
31-15
If you want to activate a paramacro through remote I/O or through the fiber
optic ring, use this t able to determine what remote I/O flag or ring point is
assigned to each variable:
Paramacro Variables
QV#
Application 1000 1001 1002 1003 1004 1005 1100 1101 1102 1103 1104
01 Drilling Cycle,No Dwell/Rapid Out H H H H H H H
02 Drilling Cycle,Dwell/Rapid Out H H H H H H H
03 Deep Hole Drill Cycle,Chip Clear H H H H H H H
04 Deep Hole Drill Cycle,Chip Break H H H H H H H
05 Right-Hand TappingCycle H H H H H H H
06 Right-Hand Solid-TappingCycle H H H H H H H
07 Left-HandTappingCycle H H H H H H H
08 Left-HandSolid-TappingCycle H H H H H H H
09 BoringCycle,No Dwell/Feed Out H H H H H H H
10 BoringCycle,Spindle Shift H H H H H H H
11 Boring Cycle,SpindleStop/Rapid Out H H H H H H H
12 Back Boring Cycle H H H H H H H
13 BoringCycle,Dwell/F eed Out H H H H H H H
14 Single AxisLiftCycle H H H H H H H H
15 SingleAxisTransferCycle H H H H H H H H
16 Two-AxisTransfer Bar Cycle H H H H H H H H
17 Single AxisCrossCycle H H H H H H H H H
18 SingleAxisFeed Cycle H H H H H H H H H
19 Two-AxisCross FeedCycle H H H H H H H H H
Remote I/O Bit
$RMI2.00 $RMI2.01 $RMI2.02 $RMI2.03 $RMI2.04 $RMI2.05 $RMO2.00 $RMO2.01 $RMO2.02 $RMO2.03 $RMO2.04
Ring I/O Point A00 A01 A02 A03 A04 A05 A11 A12 A13 A14 A15
Flag Descrip tion
Raisetransferbar
Lowertransfer bar
Advance transferbar ordrill cycle
Returntransferbaror drillcycle
Return drill cycleaxis to the toolchange
position
Stop programcycle forlocal,manualcontrol;
Set-upmode
Transferbaratraised position
Transferbaratlowered position
Transferba r atadvanced position ordrillcycle
atcycle completeposition
Transferba r atreturn ed position ordrill cycle
atcycle returne d position
Drill cycleaxis attool change position