Owner's manual

Using Transfer Line Cycles
Chapter 31
31-14
Table 31- A
Standard T-Line-9 Para macro Variables
Paramacro Wh en a 1 is assigned to this value, the control:
1000 raises the transferbarduring a transfercycle
1001 lowersthe transferbarduring atransfercycle
1002 advances thetransferbar orcompletes the drillcycle
1003 returnsthetransferbarorretractsthetool
1004 stopsthepartprogramexecutionforanymanualoperations thatneedtobe
performed onthestation. Ifthe PLCassignsa0 to this variable,then the control
goesintoautomaticexecutionmode. A cycle advance/retu rn ortransfer bar/raise
lowerrequestmustbemadeby the PLC fortheCNCtobegin automatic axis motion.
1005 performs the cycle in metric units.If this bitis setto0, then the cycle is performed in
English units.
Paramacro Wh en the control assignsa1tothisvalue,itindicatestoPALthat:
1100 the transfer barhasbeen completely raised
1101 the transfer barhasbeen completely lowered
1102 thetransferbar is fullyadvanced or the drillcycle is atthe cyclecomplete position
1103 thetransferbar is fullyreturned orthe drillcycle isat the cycle retractposition
1104 the tool isfully returned to the tool changeposition (as specifiedin the partprogram)