Owner's manual

Using Transfer Line Cycles
Chapter 31
31-12
Once you press the [STORE] softkey, the control generates a part program.
Here is an example of a part program that the control generates:
INSERT :
EDIT
FILE : 000001 POS 1*1 MODE : CHAR
MODIFY
INSERT
BLOCK
DELETE
BLOCK
TRUNC
DELETE
CH/WRD
EXIT
EDITOR
N00001(QV15 SINGLE AXIS TRANSFER CYCLE)
N00002(TRANSFER VARIABLES)
N00003IF[#1131EQ0]GOTO29 (INITIALIZES VARIABLES ONE TIME)
N00004#500=195 (TRANSFER VELOCITY)
N00005#501=1.234 (FULL ADVANCE POS.)
N00006#502=5.678 (FULL RETURN POS.)
N00007#503=4.321 (HARD STOP SENSE)
N00008(TURN OFF ALL OUTPUTS)
N00009#1100=0,#1101=0
N00010G01G90 (MODAL G CODES)
You can edit the program in three ways:
use QuickView to change the information at the prompts
use the part program editor t o change the paramacro values
use the part program editor t o change the part program
31.1.4
Editing Part Programs