Owner's manual

Using Transfer Line Cycles
Chapter 31
31-10
3. Once the correct cycle is selected, press the {SELECT} softkey. A
screen with prompts for that cycle and a graphical representation of
that cycle is displayed.
STORE
TRANSFER VELOCITY F1_____
FULL ADVANCE POSITION X1_____
FULL RETURN POSITION X2_____
HARD STOP SENSE ZONE I______
SINGLE AXIS TRANSFER CYCLE
F1
F1
X1
X2
I
4. Use the up and down cursor keys to select the parameters to be
changed or entered. The selected item is shown in reverse video.
Axis words followed by a 1 or 2 are prompting for the first and
second coordinate positions respectively.
Prompts that a re shown in reverse video indicate that this parameter
is optional a nd doesn’t need to be entered in this block.
5. Type in the desired data for that parameter on the input line of the
CRT and press the [TRANSMIT] key.
Refer to the template descriptions at the end of this chapter for
definitions of the prompts. These template descriptions assume that
the default axis names of X and Y have not changed in AMP.