Owner's manual

OffsetTable and Setup
Chapter 3
3-7
Figure 3.3
Tool Offset (Geometry) Screen
SEARCH
NUMBER
REPLCE
VALUE
ADD TO
VALUE
ACTIVE
OFFSET
MORE
OFFSET
TOOL OFFSET NUMBER:
TOOL GEOMETRY TABLE X PAGE 1 OF 4
NO. LENGTH (DIAMETER)
1 1.6396 1.6000 [INCH]
2 1.4537 .8000 [INCH]
3 .6312 .9000 [INCH]
4 5.7931 .5000 [INCH]
5 7.8432 .6000 [INCH]
6 0.000 .000 [ MM ]
7 0.000 .000 [ MM ]
8 0.0000 .0000 [INCH]
9 0.0000 .0000 [INCH]
10 0.0000 .0000 [INCH]
11 0.0000 .0000 [INCH]
12 0.0000 .0000 [INCH]
13 0.0000 .0000 [INCH]
3. Move the cursor to the offset data to be modified. Use the up, down,
left, or right cursor keys to move the cursor to the tool offset data on
the current page. Press the
{MORE OFFSET} softkey to change pages.
The tool offset data located at the c ursor will be shown in reverse
video.
4. Select the units using
{INCH/METRIC}
To select units of “mm”or “inch”for the offset data, press the
{INCH/METRIC} softkey. The units used for the currently selected
offset number will change each time the softkey is pressed.
When the units are altered, all data previously entered is converted to
the newly selected units (Inch or Metric) for that offset number.
(softkey level 3)
SEARCH
NUMBER
REPLCE
VALUE
ADD TO
VALUE
ACTIVE
OFFSET
MORE
OFFSET
MEAS-
URE
INCH/
METRIC
NEXT
AXIS
PREV
AXIS
COPY
OFFSET