Owner's manual

Using Transfer Line Cycles
Chapter 31
31-2
The 9/Series T-Line-9 system comes with a set of part program templates
for a wide variety of transfer line applications including:
Drilling/Boring/T apping Application Infeed Hole Bottom Retract Template Name
Drilling Cycle,No Dwell/Rapid Out Feed Retract Rapid Traverse QV01
Drilling Cycle,Dwell/Rapid Out F eed Dwell /Retract Rapid Traverse QV02
Deep Hole DrillCycle,Chip Clear Intermittent Feed Retract Rapid Traverse QV03
Deep Hole DrillCycle,Chip Break Intermittent Feed Retract Rapid Traverse QV04
Right-HandTapping Cycle Feed SpindleReversed /Retract Feed QV05
Right-HandSolid-Tapping Cycle F eed Spindle Reversed /Retract Feed QV06
Left-Hand Tapping Cycle Feed Spindle Reversed/Retract Feed QV07
Left-Hand Solid-Tapping Cycle Feed SpindleReversed /Retract F eed QV08
Boring Cycle,No Dwell/F eed Out F eed Retract Feed QV09
Boring Cycle,SpindleShift Feed Oriented Spindle Stop /Retract Rapid Traverse QV10
Boring Cycle,SpindleStop/Rapid Out Feed Spindle Stop /Retract Rapid Traverse QV11
Back Boring Cycle Feed OrientedSpindleStop /retract Rapid Traverse QV12
Boring Cycle,Dwell/Feed Out Feed Dwell/Retract F eed QV13
Transfer Bar an d Cross Slide Applicatio ns Use Template Name
Single AxisLiftCycle To liftand setthe partoffofandon to the transfer bar.Includes asoft touch,softset. QV14
Single Axis Transfer Cycle Totransferthe partbetweenstations. QV15
Two-Axis TransferBarCycle To lift,setand transferthe partbetweenstations. QV16
Single AxisCross Cycle Tomakeagrooveoracutinapartusingacrossslide. QV17
Single Axis Feed Cycle Tofeedacuttingtoolintooroutofapartbefore orafteracutwith across-slide ismade. QV18
Two-Axis CrossFeed Cycle A combinationof the single axis cross cycle and the single axis feed cycle. QV19
31.1
Transfer Line Cycles