Owner's manual

9/Series PAL Reference Manual
Index (General)
9/Series Mill
Table of Contents
Operation and Programming Manual
iv
Chapter 8
Display and Graphics
8.0 Chapter Overview 8-1..........................................................
8.1 Selection ofAxis PositionData Display 8-1...........................................
8.2 PALDisplay Page 8-22..........................................................
8.3 Changing Languages 8-23........................................................
8.4 Graphics 8-24.................................................................
8.4.1SelectingtheProgramforGraphics 8-24..........................................
8.4.2RunningGraphics 8-25......................................................
8.4.3DisablingGraphics 8-27......................................................
8.4.4ChangingParameters 8-27....................................................
8.4.5Graphics in Single-Block 8-33..................................................
8.4.6Clearing Graphics Screen 8-33.................................................
8.4.7DisplayingMachine InformationinGraphics 8-33....................................
8.4.8Zooming Graphics 8-33......................................................
8.6 Power Turn-onScreen 8-37.......................................................
8.7 ScreenSaver 8-39.............................................................
Chapter 9
Communications
9.0 Chapter Overview 9-1..........................................................
9.1 Setting Communications 9-1......................................................
9.1.1SettingCommunication PortParameterValues 9-1...................................
9.1.2CommunicationPortParameters 9-3.............................................
9.2 InputtingPartPrograms froma Tape Reader 9-9.......................................
9.3 Outputting PartProgramstoa Tape Punch 9-13.........................................
9.4 VerifyingPartProgramsAgainstSource Programs 9-17...................................
9.5 Error Conditions (Inputting andOutputtingPartPrograms) 9-18..............................
Chapter 10
Introduction to Programming
10.0 Chapter Overview 10-1.........................................................
10.1 Tape Format 10-1.............................................................
10.2 Program Configuration 10-6......................................................
10.2.1ProgramNames 10-8.......................................................
10.2.2Sequence Numbers 10-9....................................................
10.2.3CommentBlocks 10-10.......................................................
10.2.4BlockDeleteand MultiLevel Delete 10-10.........................................
10.2.5End ofBlock Statement 10-11..................................................
10.3 Using Subprograms 10-12........................................................
10.3.1SubprogramCall(M98) 10-13..................................................
10.3.2Main and SubprogramReturn (M99) 10-14.........................................
10.3.3SubprogramNesting 10-16....................................................
10.4 Word Formats and Functions 10-17.................................................