Owner's manual

Paramacros
Chapter 28
28-33
#5711 to 5722
Jerk
These parameters are read only. They are only applicable to the current jerk
values when S--Curve Acc/Dec mode is active. You can set these parameters
by programming a G48.5 in your part program block. Control Reset,
Program End (M02/M03), or G48 will reset these values to their default AMP
values. For more information about programming G48.x codes, refer to
chapter 18 in your 9/Series CNC Operation and Programming Manual.
5711 Axis 1 jerk 5717 Axis 7 jerk
5712 Axis 2 jerk 5718 Axis 8 jerk
5713 Axis 3 jerk 5719 Axis 9 jerk
5714 Axis 4 jerk 5720 Axis 10 jerk
5715 Axis 5 jerk 5721 Axis 11 jerk
5716 Axis 6 jerk 5722 Axis 12 jerk
#5731 to 5743
Home Marker Distance
These parameters are read only. They correspond to the current home marker
distance. These parameters will contain the distance to marker calculated
when the axis stopped after the home switch went false during the last
homing operation.
5731 Axis 1home markerdistance 5737 Axis7 home markerdistance
5732 Axis 2home markerdistance 5738 Axis8 home markerdistance
5733 Axis 3home markerdistance 5739 Axis9 home markerdistance
5734 Axis 4home markerdistance 5740 Axis10 home markerdistance
5735 Axis 5home markerdistance 5741 Axis 11homemarkerdistance
5736 Axis 6home markerdistance 5742 Axis12 home markerdistance