Owner's manual

Paramacros
Chapter 28
28-32
#5671 to 5682
Acceleration Ramps for S-Curve Acc/Dec Mode
These parameters are read only. They correspond to the active acceleration
ramps in S--Curve Acc/Dec mode. You can set these parameters by
programming a G48.3 in your part program block. Control Reset, Program
End (M02/M03), or G48 will reset these values to their default AMP values.
For more information about programming G48.x codes, refer to chapter 18 in
your 9/Series CNC Operation and Programming Manual.
5671 Axis 1accelerationramp 5677 Axis 7 acceleration ramp
5672 Axis 2accelerationramp 5678 Axis 8 acceleration ramp
5673 Axis 3accelerationramp 5679 Axis 9 acceleration ramp
5674 Axis 4accelerationramp 5680 Axis10 acceleration ramp
5675 Axis 5accelerationramp 5681 Axis 11 acceleration ramp
5676 Axis 6accelerationramp 5682 Axis12 acceleration ramp
#5691 to 5702
Deceleration Ramps for S-Curve Acc/Dec Mode
These parameters are read only. They correspond to the active deceleration
ramps in S--Curve Acc/Dec mode. You can set these parameters by
programming a G48.4 in your part program block. Control Reset, Program
End (M02/M03), or G48 will reset these values to their default AMP values.
For more information about programming G48.x codes, refer to chapter 18 in
your 9/Series CNC Operation and Programming Manual.
5691 Axis1 deceleration ramp 5697 Axis7 deceleration ramp
5692 Axis2 deceleration ramp 5698 Axis8 deceleration ramp
5693 Axis3 deceleration ramp 5699 Axis9 deceleration ramp
5694 Axis4 deceleration ramp 5700 Axis10 decelerationramp
5695 Axis5 deceleration ramp 5701 Axis11 deceleration ramp
5696 Axis6 deceleration ramp 5702 Axis12 decelerationramp