Owner's manual

Paramacros
Chapter 28
28-31
#5630
S-CurveTimeperBlock
This parameter is read only. The value represents the amount of time
(seconds converted to system scans) for a part program block’s S--Curve filter
where S--Curve Acc/Dec is applied during G47.1 mode. When it is
multiplied by the scan time, the product equals the amount of time required
by the acceleration.
This parameter is only calculated for blocks that have programmed motion
with S--Curve Acc/Dec.
#5631 to 5642
Acceleration Ramps for Linear Acc/Dec Mode
These parameters are read only. They correspond to the active acceleration
ramps in Linear Acc/Dec mode. You can set these parameters by
programming a G48.1 in your part program block. Control Reset, Program
End (M02/M03), or G48 will reset these values to their default AMP values.
For more information about programming G48.x codes, refer to chapter 18 in
your 9/Series CNC Operation and Programming Manual.
5631 Axis 1accelerationramp 5637 Axis 7 acceleration ramp
5632 Axis 2accelerationramp 5638 Axis 8 acceleration ramp
5633 Axis 3accelerationramp 5639 Axis 9 acceleration ramp
5634 Axis 4accelerationramp 5640 Axis10 acceleration ramp
5635 Axis 5accelerationramp 5641 Axis 11 acceleration ramp
5636 Axis 6accelerationramp 5642 Axis12 acceleration ramp
#5651 to 5662
Deceleration Ramps for Linear Acc/Dec Mode
These parameters are read only. They correspond to the active deceleration
ramps in Linear Acc/Dec mode. You can set these parameters by
programming a G48.2 in your part program block. Control Reset, Program
End (M02/M03), or G48 will reset these values to their default AMP values.
For more information about programming G48.x codes, refer to chapter 18 in
your 9/Series CNC Operation and Programming Manual.
5651 Axis1 deceleration ramp 5657 Axis7 deceleration ramp
5652 Axis2 deceleration ramp 5658 Axis8 deceleration ramp
5653 Axis3 deceleration ramp 5659 Axis9 deceleration ramp
5654 Axis4 deceleration ramp 5660 Axis10 decelerationramp
5655 Axis5 deceleration ramp 5661 Axis11 deceleration ramp
5656 Axis6 deceleration ramp 5662 Axis12 decelerationramp