Owner's manual

Paramacros
Chapter 28
28-27
#5090 to 5094
Probing Cycle Positions
These parameters are read-only. They correspond to values (in the
machine coordinate system) generated by the last successful probing cycle.
These cycles are programmed using G-codes G38 (circle diameter and
center measurement) and G38.1 (parallel probing cycle).
5090 G38.1rise measurement
5091 G38.1 runmeasurement
5092 G38 HoleCenter Coordinate Location on
Firsthitaxis
5093 G38 HoleCenter Coordinate Location on
Secondand Third hitaxis
5094 G38 Radius ofHole
Figure 28.1
Paramacro Parameters for G38.1 Parallel Probing
1sthit
2nd hit
Workpiece orfixture
(#5090Run distance)
(#5091RiseDistance)
Figure 28.2
Paramacro Parameters for G38 Circle Diameter and CenterMeasurement
(5092-Ycenterpoint)
(5093-Xcenterpoint)
+X
-X
+
Y
4
3
2
1
56
+
(5094-hole radius)