Owner's manual

Basic Control Operation
Chapter 2
2
-
4
8
Cycle Time -- indicates the elapsed execution time for each individual part
program. Cycle time begins counting when the cycle-start button is
pressed and ends when an M02 reset or M30 is encountered. To reset this
field to zero, use one of three methods:
press the cycle-start button to initiate program execution
turn off the control power
follow t hese steps:
1. Press t he
{ED PRT INFO} softkey if you have either operator-level or
supervisor-level access.
2. Press t he up or down cursor keys to move to this field or the next
field without changing the current value.
3. Enter a Y at t he prompt for this field.
4. Press [TRANSMIT] to clear the current value.
Workpieces Cut/After Reset -- indicates the total number of part
programs e xecuted to completion by the control since the last time “Run
Time”was reset. This counter is incremented by one each time the control
encounters a n M02, M30 or an M99 in a main part program (M99 in a
subprogram does not increment t his counter, though M02 or M30 does).
The value for this field is cleared to zero when the “Run Time”field is
cleared to zero; it cannot be changed independently.
Lot Size -- is the number of times you need to execute this particular part
program. To enter a new number:
1. Press t he
{ED PRT INFO} softkey if you have either operator-level or
supervisor-level access.
2. Press t he up or down cursor keys to move to this field or the next
field without changing the current value.
3. Enter a numeric value at the prompt for this field.
4. Press
[TRANSMIT] to change the current value.